Powder Particle Tests Help Explain Rotomolded Surface Defects

ARM’s technical director discussed how particle-size distribution affects powder flow and molded surfaces. Consistent incoming material checks can help case makers spot drift.

Illustrative editorial photo: Close-up of a gloved hand in a lab holding a petri dish with a foamy substance, possibly for scientific analysis.

Source event: May 29, 2026. In a May 2026 ARM technical answer, Nick Henwood explains that oversized powder particles may fail to melt fully and that an excess of fines can hinder powder flow. He also notes that shaker type may affect measured distributions and that there is no universal particle-size specification.

Measure trends against a controlled baseline

A case maker should agree on powder sampling and test methods with its resin supplier. Comparing results from different sieve equipment without understanding method differences can create false alarms or hide a real material change.

Surface appearance alone is not a complete quality measure, but unexplained pits or inconsistent detail deserve investigation. Incoming-powder checks, oven conditions and finished-part inspection work together.

  • Keep powder specifications and test methods consistent.
  • Record changes in resin supplier or grinding process.
  • Inspect finished shells at critical details.

The laboratory photograph is illustrative and not a sample from ARM’s article.

Source:

Association of Rotational Molders — particle-size test discussion

Illustrative photograph: Pexels

Source: Association of Rotational Molders — particle-size test discussion

Share this articleLinkedInFacebookXWhatsAppEmail