Industrial Camera Kit Uses Configurable Foam for Changing Loads

RDI Technologies adopted a custom Pelican 1450 insert for an industrial imaging kit. Removable foam plugs allow different camera, hardware and cable configurations.

Illustrative editorial photo: A neatly organized camera equipment case with labeled compartments and a hard protective shell.

Source event: April 14, 2026. Pelican’s April 2026 case study says RDI Technologies used a custom layered polyurethane insert in a Pelican 1450 for its Iris M camera system. Dedicated cavities and removable foam plugs accommodate varied configurations. RDI reported no shipping-related damage incidents after implementation, a customer-reported outcome rather than an independent guarantee.

A flexible insert still needs restraint

Field instruments often travel with different sensors or accessories. A configurable interior can avoid replacing the whole case when the load changes, but every variant still needs to prevent movement and contact between delicate parts.

The insert should make setup and inventory easy without leaving large unused cavities. Buyers can document each approved loadout and test the heaviest or most fragile configuration against the actual shipping route.

  • List approved kit configurations.
  • Check component retention in each layout.
  • Retest after camera or accessory changes.

The camera-case photograph is illustrative and is not the RDI kit.

Source:

Pelican Business — RDI Technologies Iris M case study

Illustrative photograph: Pexels

Source: Pelican Business — RDI Technologies Iris M case study

Share this articleLinkedInFacebookXWhatsAppEmail